LPG-10 Spray dryer This dryer was last used on plant proteins. Filtered hot air enters the drying tower in a spiral. Liquid is pumped into the top and atomized into droplets by a high-speed atomiser. Droplets and hot air flow in parallel, evaporating moisture to form powder. Dried powder is collected via a cyclone separator. Key Features Anti-Stick Design: Atomizer spray diameter strictly calculated; drying tower diameter enlarged to prevent material wall adhesion. Extended Residence Time: Tower height-to-diameter ratio for prolonged material exposure, enabling low-temperature spray drying. Optimized Tower Cone: Taper set to 60Á for improved flow and discharge. High-Speed Atomization: Frequency-controlled atomizer (0.75 kW) operates at 10,000-18,000 RPM for fine, uniform droplets. Advanced Percussion Hammer: Made of latest PTFE material, ensures effective vibration with reduced noise. Visibility & Access: Tower equipped with internal lighting and observation/cleaning doors. Efficient Hot Air Distribution: Spiral volute structure suppresses material upon entry, promoting orderly swirling descent. Design Requirements Heating: Electric Material: 304 stainless steel Dimensions: 2600 L x 1500W x 2950 mm H Technical Parameters (LPG-10) Model: LPG-10 Max. Water Evaporation: 8-10 kg/h Inlet Air Temperature: 140-200 C Outlet Air Temperature: 80-90 C Collection Rate: 99% Cyclone Collector: 200 mm Drying Tower Outer Diameter: 1500 mm Drying Tower Inner Diameter: 1400 mm Atomizer: 0.75 kW frequency conversion Fan: 3kw, 415V Feed pump: 0.75kw, 415V Heat source: Electric, 24kw, 415V